Secure the mounting strips to the rear of the
cabinet panel using two screws from the hardware
package.
Insert the screws in the center holes of the cabinet
pane! ("B" holes on the template) and tighten. The
screw head should pull into the wood slightly. (Use
the two % inch long screws for panels under ½
inch, or two 1¼ inch long screws for panels ½ inch
thick or larger.)
Attach the mounting brackets to the cabinet panel
using four screws.
Place the template over the mounting screws. The
mounting screws should be centered in the "A" and
"B" holes on the template. The sides of the mount-
ing brackets should match the vertical dash lines
on the template. If necessary, loosen the screws and
push the brackets into alignment and retighten.
Insert the power cord through the opening. Care-
fully slide the MA 5100 into the opening so the rails
on the bottom of the equipment slide in the track of
the mounting brackets. Continue to slide the instru-
ment in until the front panel is against the cabinet
panel.
Secure the instrument to the mounting brackets
by inserting the two knurled headed screws (from the
hardware package) into the back of the MA 5100
chassis, These screws pass through holes in the
back flanges of the mounting brackets.
How to connect
CONNECTING A LOUDSPEAKER
The MA 5100 is designed for stereo operation only.
Do not connect the MA 5100 for monophonic opera-
tion. Damage to the loudspeaker may result.
Speakers are connected at the OUTPUT barrier
strips on the back panel of the MA 5100.
Connect the leads from the left loudspeaker to
the LEFT OUTPUT barrier strip. Connect the leads
from the right loudspeaker to the RIGHT OUTPUT
barrier strip. Use lamp cord, bell wire, or wire with
similar type of insulation to connect the speakers
to the amplifier. For the normally short distances of
under 50 feet between the amplifier and speaker, #18
wire should be used. For distances over 50 feet be-
tween the amplifier and speaker use wire of a larger
diameter (#16 or #14.)
CONNECTING TO THE AUXILIARY
Any high level program source such as another
tuner or a TV set can be connected to the Auxiliary
input jacks.
CONNECTING A TAPE RECORDER
To Record:
Connect a cable from the L TAPE OUTPUT to the
left high level input on the tape recorder.
Connect a cable from the R TAPE OUTPUT to the
right high level input of the tape recorder.
To Playback/Monitor:
Connect the cable from the left channel output of
3
(24 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels