McIntosh MC205 Manuel du propriétaire télécharger pdf (Page 11)

ance of the Front Loudspeakers. If the Loud-

speaker’s impedance is 6 ohms, select the 4 ohms

setting. Refer to “General Information” Note 4 on

page 3 for additional information.

WARNING: Loudspeaker terminals are hazardous live

and present a risk of electric shock. For additional

instruction on making Loudspeaker Connections

contact your McIntosh Dealer or McIntosh Technical

Support.

12. Connect the MC205 power cord to an active AC

outlet.

Spade Lug or Wire Connections:

13. Connect the Loudspeaker hookup cables to the

MC205 Output Terminal being careful to observe

the correct polarities. Insert the spade lug connec-

tor or prepared section of the cable end into the

terminal side access hole. Then tighten the termi-

nal cap until the cable is firmly clamped into the

terminals so the lugs or wire cannot slip out. Refer

to figures 6, 7 and 8.

14. Place the IMPEDANCE Switch to the position

(4 ohm or 8 ohm) to match the impedance of the

connected Loudspeakers. In the event that some

of the Loudspeakers in the system are differ-

ent impedance, use the impedance of the Front

Loudspeakers. If the Loudspeaker’s impedance is

6 ohms, select the 4 ohms setting. Refer to “Gen-

How to Connect for a Five Channel and Zone B System (or Seven Channel System)

Figure 6 Figure 7

Figure 8

eral Information” Note 4 on page 3 for additional

information.

WARNING: Loudspeaker terminals are hazardous live

and present a risk of electric shock. For additional

instruction on making Loudspeaker Connections

contact your McIntosh Dealer or McIntosh Technical

Support.

15. Connect the MC205 power cord to an active AC

outlet.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

McIntosh MC205 Manuel du propriétaire Page 11