Mcintosh XLS360 Manuel d'utilisateur télécharger pdf (Page 14)

Figure 15

Figure 16

Installation, con’t

2. Attach either the flush mount or

angle mount bracket to the rear

of the Loudspeaker using the

two screws (just removed in the

previous step), being sure to ori-

ent the bracket as illustrated in

figures 15 and 16.

3. Determine the Loudspeaker

Mounting Location on the wall,

making sure the Mounting

Bracket will be anchored to a

stud located inside the wall.

Note: Use

extreme

caution

to avoid

any

existing

electrical

wiring,

plumbing, etc.,

located inside

the wall.

4. Refer to figures 17 and 18 to install

the appropriate Wall Bracket on the

wall (orient the bracket as illustrated)

using the supplied Mounting Screws.

If the Flush Mount Bracket is used,

Remove

Screws

Figure 14

attach the two cone shaped rubber bumpers to the rear

of the Loudspeaker, near the bottom.

Note: If the wall covering material and/or thickness is

different from the illustration, the two supplied

Mounting Screws need to be replaced with screws

of the appropriate type and length.

5.Orient the Loudspeaker with the rounded end at the

Top, carefully line up the Loudspeaker Bracket with

the Wall Bracket and lower the Loudspeaker. If the

angle mount is used, install the Locking Screw to se-

cure the Loudspeaker at the desired angle.

6. Align the Grille fasteners to the Loudspeaker Grom-

mets (two on each side). Carefully push down to secure

the Grille to the Loudspeaker.

How to Mount the XLS340 Loudspeaker On the Wall

The supplied On Wall Mounting Brackets allow for two dif-

ferent mounting positions of the XLS340 Loudspeaker rela-

tive to the wall. The first position is flush mount, with the

Loudspeaker close to and parallel with the wall. The sec-

ond position is angle mount, which places the Loudspeaker

further away from the wall and allows for horizontal rota-

tion of ± 30 Degrees. Refer to figure 19.

1. Using the supplied Allen Wrench, remove four screws

from the rear of the XLS340 Loudspeaker System. Re-

fer to figure 20.

2. Attach either the flush mount or angle mount brackets

to the rear of the Loudspeaker using the four screws

(just removed in the previous step), being sure to orient

the bracket as illustrated in figures 21 and 22.

3. Determine the Loudspeaker Mounting Location on the

wall, making sure the Mounting Brackets will be an-

chored to a stud located inside the wall.

Wall

Bracket

Loudspeaker

Bracket

Locking

Screw

Wall Mounting

Screws

Wall

Bracket

Loudspeaker

Bracket

Angled Wall Mounting

Hardware

Flush Wall Mounting

Hardware

Figure 19

Figure 17

Figure 18

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Mcintosh XLS360 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Acoustique Mcintosh XLS360