The back cover of this manual folds out to show
photographs of the front and rear panels of the MCD
7007. Fold it out to assist you in identifying and
locating the connections. The letters refer to the
paragraphs that follow.
The back panel of the MCD 7007 has connectors
labeled FIXED OUTPUT, VARIABLE OUTPUT,
REMOTE, a port marked DIGITAL OUTPUT and the
AC power cord. The VARIABLE OUTPUT is adjusted
by the front panel VOLUME buttons while the
FIXED OUTPUT is unaffected by these controls.
Use shielded cables to connect the output signal to
a preamplifier or power amplifier. To minimize the
possibility of hum, the shielded cables should be of
parallel construction or loosely twisted together and
located away from the speaker connecting cables
and AC power cords. Be certain to use good quality
shielded cables for all interconnections. Your dealer
can advise you on the kind and length of cables that
will best suit your installation.
A. FIXED OUTPUT
The FIXED OUTPUT jacks are used to feed
program to a stereo preamplifier or other
equipment with its own volume control.
B. VARIABLE OUTPUT
Use the VARIABLE OUTPUT jacks to connect to
a power amplifier or a tape recorder where
control of the volume at the player is desired.
There is no difference in the signal quality at
either pair of output jacks. Both pairs of output
jacks may be used simultaneously.
Connect the audio output of the player to the
"CD", "AUX", or other high level input on the
preamplifier. Do not connect to the "PHONO"
input. Connect the Right player output to the
right preamplifier input and the Left player
output to the left preamplifier input.
C. REMOTE
The REMOTE control connector is designed for
use with the Mclntosh multi-area infrared remote
control systems. With these systems, you can,
from a hand-held remote control, operate the
disc player and the entire system from various
listening areas.
D. DIGITAL OUTPUT
The digital data stream is available from this
port for use in systems that can accept digital
data directly.
E. AC POWER
Plug the AC power cord into a 120 volt 50/60
Hz receptical. The plug blades are polarized so
be certain the plug is fully inserted in the outlet
to prevent blade exposure.
CAUTION: TO PREVENT ELECTRIC SHOCK, DO
NOT USE THE (POLARIZED) PLUG ON THIS UNIT
WITH AN EXTENSION CORD, RECEPTACLE, OR
OTHER OUTLET UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
INSERTING THE BATTERIES IN THE
REMOTE CONTROL
Your Mclntosh Compact Disc Player includes an
infrared Remote Controller. In your hand you have
the ability to control normal operating functions of
the disc player.
The controller runs on two AA, 1.5 Volt batteries.
Slide open the cover on the back of the remote
controller and insert the batteries as shown in the
diagram in the battery compartment, then slide the
cover closed again.
Battery life is normally about one year. Remove the
batteries as soon as they are dead to prevent damage
by possible battery leakage. The batteries should be
removed, also if the remote controller is not used for
a long time.
6 HOW TO CONNECT
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels