Mcintosh C2300 Manuel d'utilisateur télécharger pdf (Page 19)

How to Operate the C2300, con’t

Output 1 and 2

Press the Front Panel OUTPUT 1 / OUTPUT 2 Push-but-

ton or by using the Remote Control and pressing the 2nd

Push-button followed by the OUTPUT 1 / OUTPUT 2

Push-button to send audio to separate Power Amplifiers

connected to the rear panel OUTPUTS 1 or 2 Jacks. It also

activates the POWER CONTROL OUTPUT 1 /OUTPUT

2 Jacks on the rear panel of the C2300. To stop the Audio

and Power Control Signals from going to the separate

Power Amplifiers press the same Push-button(s) a second

time.

Headphones Jack

Connect a pair of dynamic headphones with a 1/4”

(0.635cm) stereo phone type plug to the Headphones Jack

for private listening.

Output Meters

The C2300’s Output Meters indicate the Output Voltage

available at the MAIN and OUTPUT 1 & 2 Jacks to drive

Power Amplifiers. Refer to figure 27. The Meters are cali

brated in dB

(decibels) and

respond to all

the peaks con-

tained in the

musical infor-

mation. They

indicate to an

accuracy of at least 95% of a single cycle from a 2000Hz

tone burst.

The Meter Electronic Circuitry “Time Stretches” the Meter

Drive Signal so the Meter Pointer pauses just long enough

for the human eye to see it and is followed by a moderate

decay rate.

How To Make A Recording

1. Select the Source Input Signal you wish to record.

2. Adjust the record level using the recorder volume con

trol and proceed with the recording process.

3. To listen to the playback of the program source just

recorded, press the RECord MONITOR Push-button.

Note: The C2300 SRVR (REC) OUTPUTS are not affected

by the VOLUME or BALANCE controls.

Figure 26

Reset of Microprocessors

In the unlikely event the controls of the C2300 stop func-

tioning, the microprocessors can be reset by performing

the following:

1. Press and hold in the STANDBY/ON Push-button for

approximately five seconds and then release the push-

button.

2. Press the STANDBY/ON Push-button, the C2300 will

resume normal operation.

Note: This can be performed with the C2300 On or in the

Standby Mode.

Figure 27

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Mcintosh C2300 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Mcintosh C2300