McIntosh D100 Manuel du propriétaire télécharger pdf (Page 13)

Your McIntosh D100 has been factory configured

allowing for immediate enjoyment of superb audio.

If you wish to make changes to the factory default

settings, a Setup Feature is provided to customize the

operation by using the Front Panel Information Dis-

play. Refer to the D100 Front Panel Illustration on the

previous page while performing the following steps.

Note: If the D100 is currently On, proceed to step 2.

1. Press the STANDBY/ON Push-button on the Front

Panel or press the (Power) Push-button on the

Remote Control to switch On the D100. The D100

will go through a brief startup intialization with

the Front Panel Information Display indicating the

Level percentage (Volume) and then the last used

Input Source. Refer to figures 1 and 2.

2. Press the SETUP Push-button repeatedly until the

Front Panel Information Display indicates “Firm-

ware V1.00” or higher. Refer to figure 3.

3. Press the SETUP Push-button to exit from the

Setup Mode. The LED above the SETUP Push-

button will extinguish and the Front Panel Display

will revert back to its normal display. Refer to

figure 2.

The D100 functionality is controlled by internal

software know as “Firmware”. The current Version of

the Firmware can be identified by utilizing the Setup

Mode.

1. Repeatedly press the SETUP Push-button until

“FIRMWARE V_ _.__” is indicated on the

Front Panel Information Display. Refer to figure 3.

3. Press the SETUP Push-button until the LED above

the SETUP Push-button is extinguished.

How to Operate the Setup Mode

The Default Settings Chart that follows indicates the

Function Name, Default Setting and the Page Number

for additional information.

Default Settings

Firmware Version

Default Settings

Function Name Setting Page No.

AUTO POWER OFF

DISABLED 13

BRIGHTNESS

(Display)

HIGH 13

FI R M WA R E V_ _.__ 13

In some Countries and/or Localities the default setting of

Auto Power Off Feature is ENABLED.

Setup

Brightness

Figure 1

LEVEL 76%

Figure 2

1 COAX1 . . . . . .

FIRMWARE V1.00

Figure 3

The D100 incorporates an Auto Power Off Feature,

which can automatically place the Digital Preampli-

fier into the Power Saving Standby/Off Mode. This

occurs approximately 30 minutes after there has been

an absence of a Digital Audio Signal on the currently

selected D100 Input. If it is desirable to change the

current Auto Off Setting (Disabled or Enabled) per-

form the following steps:

1. Press the SETUP Push-button.

2. The Front Panel Display will momentarily indi-

cated “Auto Power Off”. Refer to figure 4.

3. The display will then indicate the current setting,

either Disabled or Enabled. Refer to figures 5

and 6.

4. Rotate the LEVEL Control either clockwise or

counterclockwise to change the current setting.

5. Press the SETUP Push-button repeatedly until

the LED above the SETUP Push-button is extin-

Auto Power Off

The Front Panel Information Display Brightness may

be changed from the default setting. The D100 will

remember the brightness preference, High (default set-

ting) or Low Illumination. Follow the steps below to

reduce the Display Brightness:

1. Repeatedly press the SETUP Push-button until

“BRIGHTNESSS HIGH” is indicated on the

Front Panel Information Display. Refer to figure 7.

2. Rotate the LEVEL Control to change the Bright-

ness to the Low Setting. Refer to figure 8.

3. Press the SETUP Push-button repeatedly until

the LED above the SETUP Push-button is extin-

guished and the Front Panel Information Display

indicates the currently selected digital source

Input. Refer to figure 2.

AUTO POWER OFF

Figure 4

DISABLED

Figure 5

ENABLED

Figure 6

BRIGHTNESS HIGH

Figure 7

BRIGHTNESS LOW

Figure 8

guished and the Front Panel Information Display

indicates the currently selected digital source

Input. Refer to figure 2.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

McIntosh D100 Manuel du propriétaire Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement musical McIntosh D100